Technical services, thoughtfully done

Keep making.
I’ll handle the rest.

LarsonLabs helps makers in the Central Texas area get unstuck with practical, transparent repair services for the tools they rely on.

01 / Service stage

3D Printer Repair

3D Printer Repair in progress

Hands-on, human support

Get you and your printer back to work, ASAP.

Bring the stubborn jams, odd noises, and mystery errors. I’ll find the fault, explain the fix, and get your machine printing again.

24–48hr typical turnaroundClear pricing before workLocal hands-on service
Diagnostic workbench with repair tools

02 / Diagnosis

Not sure what’s wrong? Start with a diagnosis.

That’s fine. I’ll inspect the machine, test the likely failure points, and tell you what it needs before any repair work begins.

The $75 diagnostic is credited toward labor on any repair you accept.

03 / Pricing

Straightforward options.

$40

Maintenance

A practical tune-up for a printer that works, but not as reliably as it should.

  • Clean and inspect
  • Bed and axis check
  • Basic callibreation and general maintenance
Most common

$60/hr

Standard Rate

For common mechanical, electrical, and print-quality issues with a clear path to repair.

  • Fault isolation
  • Parts installation
  • Test print and handoff

$75/hr

Complex Rate

For intermittent faults, board-level troubleshooting, or repairs that need deeper bench time.

  • Advanced diagnostics
  • Custom troubleshooting
  • Detailed repair notes

Can't bring it to me?

Pick-up and drop-off services are available within a 25-mile radius for $10 each way. Outside the radius? Ask for a quote.

Need onsite repairs? No problem!

Onsite repairs offered starting at $150/hr.

04 / Reach out

Let's get you unstuck.

Tell me what's happening, even if you don't have the right words for it. A few details are enough to start the conversation.

hello@larsonlabs.com

Repair services disclaimer. Repairs are performed on a best-efforts basis, and not every fault is repairable. The $75 diagnostic fee is applied to labor on accepted repairs and is not refundable if the repair is declined. Customer-supplied or third-party parts are not covered by a warranty. You are responsible for backing up data and settings on your devices before service. Liability is limited to the amount paid for the service.

Pricing scheme. Due to the nature of the work, most repairs are done at my facility. While there, rates only apply to diagnostic and repair time—not time spent printing—and all work is charged at 15-minute intervals. Repairs done at customer sites are charged at the hourly rate in 15-minute intervals for the total time I am on-site.